OUTPUT SIGNAL 1: Serial Incremental

  OUTPUT SIGNAL 2: Serial Incremental

  OUTPUT SIGNALS: Independantly Buffered

  OUTPUT IMPEDANCE: Approx 5k

  SIGNAL DUTY CYCLE: Sensed Tooth Dependant Approx 50% Schmidt
     Triggered

  CURRENT SOURCE CAPACITY: 15 Ma. Max

  OUTPUT SIGNAL FREQUENCY: 0 - 100 KHZ

  GAP: .045 - .060 (Mass Dependant)

  MAX RESOLUTION: .075 In.

  SUPPLY VOLTAGE: 6.2V - 38V DC

  OUTPUT SIGNAL VOLTAGE: 0 - Supply Minus 1.4V Peak To Peak

  CABLE: 20 Ga. 4 Wire PVC Jacket Foil Shielded Floating

  OUTPUT TERMINATION    Customer Specified

  OPERATING TEMPERATURE: -20 Deg C To +80 Deg C With PVC     Jacketed Cable
    -40 Deg C To +150 Deg C With Teflon Cable

  CHEMICAL TOLERANCE: Impervios To Salt, Water, Oil & Transmission     Fluid

  MECHANICAL SHOCK: 30G Static And Dynamic (1k)

1. TURN LOCK NUT APPROXIMATELY 1/8 IN FROM SENSOR FLANGE     HEAD.

2. SCREW IN SENSOR UNTIL LOCK NUT BOTTOMS OUT AGAINST     TRANSMISSION HOUSING.

3. ALIGN INDEXING MARK SO THAT THE MARK FACES THE GEAR     TEETH.

4. LOCK SENSOR IN PLACE BY HOLDING THE FLANGE HEAD AND     TIGHTENING THE LOCK NUT AGAINST THE   TRANSMISSION     HOUSING.

5. IF OPERATION IS NOT ACHIEVED, LOOSEN LOCK NUT AND TURN     SENSOR FLANGE HEAD IN ONE COMPLETE TUN AND LOCK.

NOTE: ORIENTATION OF SENSOR TO GEAR IS IMPORTANT.          MISALIGNMENT OF 15 DEGREES IN EITHER DIRECTION MAY AFFECT OPERATION.

Contact us and we will direct you to a supplier in your area.

All pictures on this site are the property of Arthur Allen Mfg. Co., Inc.
and are not allowed to be used on any other site.